Setting Work Setpoint; Setting The Power Supplied To The Top Element And Power Supplied To The Bottom Element Of The Oven - GGM gastro POP434E Mode D'emploi

Setting work setpoint

To set the work setpoint, operate as follows:
11. Ensure that the appliance is not off and that no other
procedures are in progress.
12. Press and release the key for the "TOP" or the
"BOTTOM" element of the oven: the LED
LED of the "UPPER" display will flash and the top of
the display will flash the setpoint value.
13. Press and release the "INCREASE" key or the
"DECREASE" key within 15 s to set the setpoint value;
14. Press and release two times the key for the "TOP" or the
"BOTTOM" element of the oven or do not operate for 15
s: the LED
appliance will leave the procedure.
To prematurely leave procedure, operate as follows:
15. Do not operate for 15 s (any changes will be saved).
Setting the power supplied to the top element and
power supplied to the bottom element of the oven
To set the power supplied to the top element of the oven,
operate as follows:
21. Ensure that the appliance is not off and that no other
procedures are in progress.
22. Press and release two times the "TOP" element key: the
LED of the "LOWER" display will flash and the top of
the display will flash the power value.
23. Press and release the "INCREASE" key or the
"DECREASE" key within 15 s to set the power value; the
c0 and c1 parameters are also shown.
24. Press and release the "TOP" part key or do not operate
for 15 s: the LED
leave the procedure.
To prematurely leave procedure, operate as follows:
25. Do not operate for 15 s (any changes will be saved).
and the LED will go off and the
will go off and the appliance will
and the
66