Formular For Documentation Of The Setting Parameters - DOLD UH 5947 Manuel D'utilisation

Formular for documentation of the setting parameters

Device:
Device No:
Configurated by:
Date:
1. Parameterization
1.1 Monitored motion
1)
Translational
Rotational
1.2 Encoder type
1)
Lin. encoder
Rot. encoder
1.3 Encoder selection
RJ45:Encoder + E2
RJ45:Encoder
E1 + E2
1.4 Lead / transm.
Transmission
: 1
Lead
1.5 Encoder settings
Signal form
sin/cos or TTL
HTL
Resolution
xxxxxx e.g. xxx,xxx
1.6 Sensor settings
Sensor type
pnp
npn
Resolution E1
Resolution E2
1.7 Speed limits
Automatic max
Automatic min
Set-up max
Set-up min
Standstill
1.8 Times
Start override
Release delay
Switch-off monit.
1.9 Start type
Manual start
Automatic start
1.10 Prot. door monit.
Simultaneity on
Simultaneity off
Please cut off and file it !
UH 5947
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
mm
x
Imp/U e.g. mm
Imp/U e.g. mm
Imp/U e.g. mm
U/min e.g. m/min
U/min e.g. m/min
U/min e.g. m/min
U/min e.g. m/min
U/min e.g. m/min
s
s
s
Parameterization
Parameterization using the display
To enter the device's parameterization mode the following key combina-
tion is provided:
Press and keep pressed the right key at first. Then, press the left key
(see below). A display test follows and has to be acknowledged using the
OK key (right key) when it was successful. Then, it is possible to change
the parameterization. Before the device adopts changed parameters, they
must be confirmed once more for safety reasons.
Automatic operation
80 - 100 m/min
Standstill
< 10 m/min
ü
57
M10375
UH 5947 / 10.01.17 de / en / fr / 813