50
7.0 WIRING DIAGRAM
7.1
ELECTRONIC WIRING DIAGRAM
EN
This appliance comes equipped with a battery back-up. If this back-up is used, install 4AA batteries (not
supplied) into the holder and connect to the wire harness.
TRANSFORMER
BATTERY
HOUSING
(SUPPLIED IN
MANUAL BAGGIE)
NOTE: The battery holder was supplied with your appliance but not connected. In an event of a power
failure, install two "AA" batteries in the holder and attach to wire harness as illustrated above.
W415-1613 / D / 09.20.17
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH
ACS/IPI
SWITCH
(OPTIONAL)
ON / OFF
SWITCH
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH AND
CONNECT TO AN
OPTIONAL THERMOSTAT.
DC SUPPLY
WARNING
!
IPI / CPI
VALVE
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
IPI BOARD
DFC
69.7