Top Exit - Napoleon B46NTR Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.13

TOP EXIT

FLUE PIPE
WITH GASKET
FAILURE TO CREATE A SEAL TO THE FIREBOX WITH THE EXHAUST COLLAR ASSEMBLY WILL CAUSE
THE APPLIANCE TO FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
NOTE: This appliance has been factory shipped as a rear vent.
Remove the safety screen and glass front, refer to " SAFETY SCREEN / DOOR REMOVAL AND
A.
INSTALLATION" section.
Remove the contents from the firebox and set aside. The
B.
flue collar from the top of the log carton will be needed.
To ease assembly, remove the four hex head screws
C.
securing the deflector from inside the top front of the
firebox.
FLUE PIPE
D.
Remove the single screw from the outer cover on
WITH GASKET
back of the appliance.
Remove the four screws on the 7" (178mm) intake
E.
collar assembly; set the intake collar and gasket
aside. Be careful not to damage the gasket.
Remove the outer cover plate (without knockout)
F.
from the top shell of the appliance.
Remove the inner cover plate and gasket by
G.
removing the four screws. Reinstall the inner cover
plate and gasket onto the back of the appliance.
Remove and discard the 1 1/2" thick batt of
H.
insulation.
Place the 7" (178mm) intake collar and gasket into
I.
the top of the appliance and secure with the four
screws.
Reinstall the outer cover plate
J.
(without knockout) over the 7"
(178mm) exhaust collar assembly
and secure.
From inside the firebox, install
K.
the 4" (102mm) exhaust collar up
through the top of the firebox and
secure with the the four hex head
3/8" thread cutting screws. NOTE:
Do not overtighten. The gasket
needs only to be snug against the
firebox.
Reattach the top deflector, log set, glass
L.
door and safety screen.
FLUE PIPE
WITH GASKET
!
TO TOP VENT
TO TOP VENT
FLUE PIPE
WITH GASKET
WARNING
DEFLECTOR
DÉFLECTEUR
OUTER
COVER PLATE
J
(without
knockout)
F
OUTER
COVER
PLATE
F
(without
knockout)
I
23
EN
E
GASKET
E
INTAKE COLLAR
ASSEMBLY
D
OUTER COVER
the
E
GASKET
E
INTAKE COLLAR
ASSEMBLY
D
OUTER COVER
INNER
COVERPLATE
G
GASKET
EXHAUST FLUE COLLAR
INNER
COVERPLATE
G
GASKET
W415-1613 / D / 09.20.17

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

B46ntreB46ptrB46ptre

Table des Matières