Figure 2-14 Connect Disposable Set To Feeding Tube - Moog infinity orange Mode D'emploi

Step 6
Confirm food type to be delivered (formula or
human milk) before starting pump by pressing
FOOD TYPE
the key. Press the
change between formula and human milk.
Step 7
Connect end of disposable set to the patient's
enteral feeding tube (Figure 2-14).
Step 8
RUN/PAUSE
Press the
Display will show programmed rate and the arcs
around the run symbol will rotate (Figure 2-15).
While pump is running, the following may
be viewed by pressing the appropriate
key: RATE, DOSE, and
To view the amount delivered in the current feeding,
VOL/TOTAL
press the
will reset itself when the previously programmed dose
has been completed and a new feeding is started, or if
a feeding is interrupted and Rate or Dose is changed.
To view the amount delivered over the course
of several feedings press the
a second time. Display will read TOTL then the
amount. This counter never resets itself. It can
only be reset by the user (Figure 2-17).
While pump is running, the settings cannot be
changed and the Prime feature is disabled.
If you want to stop pump at any time, press the
RUN/PAUSE key. Display will show rate, and
pump will be in pause mode. Pump will save the memory of where it was in the
feeding before being paused. Or, turn pump off by pressing the
+ -
or key to
key. Pump will begin running.
FOOD TYPE.
key (Figure 2-16). This counter
VOL/TOTAL
key
11
2. DIRECTIONS FOR USE
Figure 2-14 Connect disposable
set to feeding tube
Figure 2-15 Pump is Running
Figure 2-16 Amount
Currently Delivered
Figure 2-17 Total
Amount Delivered
ON/OFF key.
© Copyright 2020 Moog, Inc.