babyzen YOYO2 Guide D'utilisation page 11

en
Installation of backrest
1. Using a coin, retract the white pin.
2. Insert backrest from the back.
3. On the side of backrest without white
pin, mount hinge into YOYO
4. On the right hand side of backrest,
align hinge.
5. Push white pin in to lock the backrest
into position.
Installation of seat base (fabric)
1. Mount seat base fabrics over
backrest.
2. Slot plastic clips onto both sides of
stroller frame.
3. Secure the straps around the lateral
tubes.
4. Under the seat base fabrics, secure
the two straps by inserting into the
corresponding slots in seat base.
5. On the front centre of seat base
fabrics, secure strap by looping
through slot in seat base.
6. On the sides of seat base fabrics,
secure the straps around horiztonal
bar by looping through buckle on the
back.
Installation of canopy
1. Insert large metal wire inside the front
rim of the canopy.
2. Insert small metal wire inside rear rim
of the canopy.
10
3. Insert ends of the small wire into
the inner mounts of handlebar, and
secure with cord loops.
4. Position the cord loops of large wire as
indicated.
.
2
5. Insert ends of the large wire into the
external mounts of the handlebar,
and secure with cord loops.
6. Affix the rear section of canopy to the
back of backrest.
Installation of basket and shoulder strap
1. Hook shoulder strap to the rings
underneath seat.
2. & 3. Secure the four straps on front
of basket by looping through slots
located on footrest.
4. & 5. On the rear rim of basket, secure
the straps by looping through the slots
located on rear legs.
Installation of seat pad and harness
1. Thread the harness shoulder straps
through one of the four pairs of slots
on the pad, according to the height
of your child.
2. Thread the harness waist straps
through the slots on the pad.
3. Thread the harness crotch strap
through the slot on the pad.
4. Affix the front loop of seat pad to the
hook under seat.