Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Timer
o
Using the timer, you can programme the fan heater to switch off automatically
after the selected time.
o
Switch the appliance on by pressing the rotary knob (1).
o
Now press the "MODE/SET TIME" button (2) for approx. 3 seconds until you
hear a beep and the LED lamp lights up behind the "0.5" setting on the display
(3). The appliance will now turn itself off after half an hour.
o
You can programme the switch-off time in half-hour intervals in a range from
0.5 to up to 7.5 hours by turning the rotary knob (1).
o
CAUTION: If you fail to turn the knob (1) within more than approx. 5 seconds,
the appliance will switch from timer back to normal mode. For any further time
programming, press the"MODE/SET TIME" button (2) again for approx. 3
seconds until you hear the beep.
o
You can check the heating time by adding up the hours indicated by the lit-up
LED lamps. E.g.: If the LED lamps are lit beside "2" and "1" on the display (3),
you have programmed 3 hours of heating time.
o
Delete the programming by pressing the rotary knob (1), which powers the
appliance down, and then switching it on again.
Oscillation
o
You can switch swivel motion on and off by pressing the OSC button (6).
REMOTE CONTROL
o
The "POWER" button (7) switches the
appliance on and off.
o
The "MODE" button (10) offers a choice
between "high", "low" and "auto" mode.
Check the LED lamps on the control panel
(5)
o
Adjust the temperature by using the
"TEMP" button (8) in "auto" mode.
o
The "OSC" button (9) switches swivel
motion on and off.
o
Timer: Proceed as described above. Use
the "TIMER" button (11) to switch on
the timer and the "TEMP" button (8) to
programme the time.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
27
Publicité
Table des Matières
