Summary; Functional Description; Safety Equipment; Initial Operation - Grizzly BRM 41-125 BSA Traduction De La Notice D'utilisation Originale

Summary

1 Upper handle bar
2 Drive catch
3 Safety catch
4 Lower handle bar
5 Cable clamp
6 Impact protection
7 Oil filler cap with dipstick
8 Filler cap
9 Air filter box
10 Air filter (not visible)
11 Petrol pump (primer)
(not visible)
12 Engine cover
13 Exhaust guard
14 Spark plug connector with
spark plug
15 2 front wheels
16 Sheet steel housing
17 2 rear wheels
18 Lever for cutting height adjust-
ment
19 Grass collection box
20 2 screws, 2 washers and 2 star
knob nuts to fasten the bar
21 Starter cord guide
22 Starter handle with starter cord
23 Gas lever

Functional Description

The equipment is driven by a powerful
four-stroke engine (Briggs & Stratton
450E Series). The Easy-Start function,
the rear wheel drive and the blade brak-
ing function make the equipment easier to
operate.
The equipment is fitted with a high quality
steel metal casing, a grass collection box
and a foldable handlebar. In addition, the
height of the equipment can be adjusted
in 7 levels and has easy-moving wheels.
Refer to the following descriptions for a
functional description of the controls.

Safety Equipment

3 Safety catch
The equipment stops when the
safety catch is released.
6 Impact protection
protect the operator from parts
that are flung out and from ac-
cidentally touching the blades
when mowing with no grass col-
lection box.
13 Exhaust guard
prevents hands or combustible
materials from coming into con-
tact with a hot exhaust

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Observe the Briggs & Stratton in-
struction manual supplied.
Before starting the equipment, you must
- Remove the Protective Caps
- Install the handle bar
- Install the grass collection box
- Install the starter cord
- Fill with engine oil
- Fill with petrol
- adjust cutting height if required

Installing the Handle Bar

Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. With a wrench (size 13) remove
bar mounting and nuts (24) on
UK
83