The "Routes" Menu - Roco and Fleischmann WLANmaus Z21 Mode D'emploi

Options: "ON" or "OFF."
To select an option, use the arrow keys.
▪
Confirm with the
TIONS" level.

4. The "ROUTES" Menu

The WLANmaus uses the "ROUTES" menu to manage all data, which is required for the locomotive library
and for switching the corresponding turnouts.
4.1 „NEW":
Use this menu item to add a new route to the library.
4.2 "EDIT":
Use this menu item to edit or supplement the data of a route stored in the library.
The first image shows the last route used while in route mode. Use the arrow keys to select the route
to be edited.
– Confirm with " OK-key.."
You now have the option of changing the route name. The insertion point flashes at the last slot. Use
the left arrow key to delete letters / numbers and reenter them using the function keys.
– Confirm with " OK-key."
The first turnout saved in the route now is depicted.
– Press the desired arrow key to change only the position of the turnout.
– Press the Shift and STOP key to delete the turnout.
– Skip any turnouts not to be edited by using the Shift and the right arrow key.
The next turnout is reached with the key combination Shift and right arrow key.
– Once you have browsed through all turnouts of the route you can create one or several new turnouts.
Please read Chapter 2.7.1 for additional information.
– If you do not wish to create a new turnout and all desired changes have been made, confirm with the
"Light /OK" key. You are then returned to the "EDIT" start level.
4.3 "DELETE"
Use this menu item to remove a locomotive from the library.
The first image shows the last route used while in route mode. Use the arrow keys to select the route
to be removed.
– Confirm with " OK-key.."
8010813920_II_2022.indd 85 8010813920_II_2022.indd 85
the F0 key switches on the step lights for around two seconds. After a further two
seconds, the rear red warning lights are activated. The F4 key is used to start rotating
the coachwork. This is only possible at speed step 0. During the rotating process, the
conveyor is braked to prevent any uncontrolled movement due to the geometry
change in the model being monitored.
OK-key. You will then be returned to the initial "SNOW BLOWER FUNC-
Menus
85
09.02.2022 09:17:33 09.02.2022 09:17:33