Routes - Roco and Fleischmann WLANmaus Z21 Mode D'emploi

2.6 Routes

The WLANmaus does not only offer the possibility to switch individual turnouts but can also combine
several turnouts into one route and switch together by pressing only one key. A route is a distance cov-
ered by a train crossing several turnouts. For example, this can be used to move a freight train from a
feeder track across sever turnouts switched with a single command and onto the main track without
interruption.
Use the WLANmaus to configure 10 routes each with a maximum of 10 turnouts. However, it is not
possible to embed a route into another route, i. e. one route cannot be combined with another route.
Driving operation will not be interrupted in route mode! For this reason, the drive symbols are
also shown on the display. It is possible to control the locomotive last active using the speed
controller, and also to trigger an emergency stop.
No feedback takes place regarding the position of turnouts or whether the train has already
passed the route or not.
New creation of a route
Input
/
...
64
64
8010813920_II_2022.indd 64 8010813920_II_2022.indd 64
Display Note
Press the key. You will reach the
turnout last selected, here turnout 24.
keys simultaneously, you will
get into route mode.
If no route has been created yet, see ad-
jacent image.
If routes have already been created, you
can find free memory space (designated
"NEW?") using the arrow keys.
Confirm using the OK key.
Now the name of the route must be
entered, for example FNOSU for "route
North-South". 10 places are available to
you for the purpose.
Carry out input in the same way as
when creating a locomotive in the lib-
rary.
Confirm with the OK key.
09.02.2022 09:16:39 09.02.2022 09:16:39