Technical Data; At2000 Cpk; Power Pack Cpk; Noise And Vibration Information - HellermannTyton Autotool 2000 CPK Manuel D'utilisation

29
f Change faulty tie advancer
advancer must face down.
The tie advancer can be inserted in both directions.
30
f Position the tie advancer as illustrated.
A Position of tie advancer message appears
if positioning is not correct, à „Display messages" on
page 22.
f Close roller block .
5
f Tighten screw
.
4
f Close gate .
1
AT2000 CPK • Operating Instructions • 04-2015 • 106-29004
6
. The teeth of the tie
6

10 Technical data

10 .1 AT2000 CPK

Max . power draw
Input voltage
Size L × W × H
Weight
Bundle thickness

10 .2 Power pack CPK

Line voltage
Line frequency
Protection class
Size L × W × H
Weight

10 .3 Noise and vibration information

Emission sound pressure level L
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Aggregate figure for vibration a
Uncertainty K
The vibration level as stated here is a measured value obtained
by the standardised method set out in EN 60745-1:2009; it
can be used for the purposes of device comparison.
The figure for vibration stated here is for the power tool
in conditions of its intended use and can differ from the
actual figure for the power tool in conditions of other use
or if not adequately serviced.
Accurately estimating vibration load over a certain work
period entails making due allowance for the times
during which the device is switched off or running, but
not actually in use. This can reduce vibration load over
the entire work period by a significant margin.
f Define additional safety measures to protect the operator
from the effects of vibration, for example:
• Servicing of power tools and use tools
• Keeping hands warm
• Workflow organisation
Technical data
50 W
25.2 V
approx. 285 mm × 86 mm × 245 mm
approx. 1800 g
up to max. 20 mm in diameter
100 V – 230 V
50/60 Hz
I
approx. 260 mm × 110 mm × 93 mm
approx. 1300 g
65 dB re20 μPa
pA
3 dB
76dB re1pW
3 dB
0.8 m/s
2
h
1.5 m/s
2
29