Publicité
Les langues disponibles
Les langues disponibles
6.
Turn your component on and press CHANNEL+. If it responds, setup is
complete. Your AUX button is now equal to a TV, VCR, CBL or SAT button,
depending on what mode you chose at step 3.
Searching for codes:
1.
Turn on the device you want to control.
2.
Press and hold SETUP until the LED indicator lights steadily. Release Set-up
button.
3.
Press the mode button that matches the equipment you wish to control. The
LED blinks once.
4.
Press CHANNEL+ repeatedly until the device to be controlled changes
channel. If you go past the code accidentally press REW [<<] to step back (for
first step push button twice).
5.
Press and release the ENTER button to complete the setup.
Note: You may have to press CHANNEL+ many times (>50). If the device does not
have a Channel Up function, use the PLAY [>] button (VCR only) or the POWER
button.
Identifying codes found using the search procedure:
1.
Press and hold SETUP until the LED indicator lights steadily. Release the Set-
up button.
2.
Press the mode button that matches the equipment you wish to identify. The
LED blinks once.
3.
Press and release SETUP. The LED blinks once.
4.
To find the first digit, press each number button from 0 to 9 until the LED
blinks. The number you pressed is the first digit of the code.
5.
Press each number button from 0 to 9 as above to find the second digit.
6.
Press each number to find the third digit. When the third digit has been found,
the LED will go out. Write down the found code on the label of the battery
compartment.
4
Publicité
