Care And Maintenance - Kärcher WD 3.2 Série Mode D'emploi

Crevice nozzle
 For edges, joints, heaters and hard to reach loca-
tions.
Floor nozzle
(with inserts)
Illustration
 Note: For vacuuming dry dirt or water off the floor -
always work with the insert (brush strip and rubber
lip) in the floor nozzle.
Adapter
Illustration
 To connect the suction hose with an electric tool
 Adapt the adapter to the connection diameter of the
electric tool using a knife if necessary.
Operation
ATTENTION
Always work with an inserted cartridge filter during wet
as well as dry vacuum cleaning!
Before Startup
 Illustration
Mount loose parts delivered with appliance prior to
start-up.
 Illustration
Recommendation: To vacuum fine dust, use the
filter bag.
Start up
 Illustration
Connect accessories.
 Illustration
Plug in the mains plug.
 Illustration
Turn on the machine.
Dry vacuum cleaning
ATTENTION
Check the filter for damage prior to installation and re-
place as necessary.
Work with a dry cartridge filter only!
Illustration
 Recommendation: To vacuum fine dust, use the
filter bag.
Information filter bag
– The filling level of the filter bag depends on the dirt
that is sucked in.
– The filter bag needs to be replaced more frequently
while sucking in fine dust, sand, etc.
– Clogged filter bags can burst - therefore make sure
to replace the filter bag in a timely manner!
ATTENTION
Vacuum cold ashes only when using a pre-filter.
Order no. basic design: 2.863-139.0, premium design:
2.863-161.0.
Wet vacuum cleaning
 Attach the accessories to vacuum moisture or wet-
ness to the suction tubes or directly to the handle.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam forms or liq-
uids escape!
Working with electrical power tools
Illustration
 Adapt the adapter to the connection diameter of the
electric tool using a knife if necessary.
 Connect the adapter to the handle of the suction
hose and connect it to the electric tool connection.
Connect the mains plug of the electric power tool to
the vacuum cleaner.
Illustration
 Switch the vacuum cleaner to Position II and start
working.
Note: As soon as the electric tool is switched on, the
suction turbine starts with a 0.5 second delay. If the
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up
the remaining dirt in the suction hose.
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
 Illustration
Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
 Turn off the appliance.
 Illustration
Hook the floor nozzle into the parking position.
 Turn off the appliance and disconnect the mains
plug.
Empty the container
 Illustration
Remove the appliance head and empty the reser-
voir.
Storing the appliance
 Illustration
Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.

Care and maintenance

 Clean the appliance and accessory parts made of
plastic with a commercial plastic cleaner.
 If required, rinse the container and accessories
with water properly and dry them before reuse.
Illustration
 Only clean the cartridge filter under running water;
do not wipe or brush. Let it dry completely prior to
installation.
– 8
EN
Blowing function
Finish operation
13