Identifying Detector Status By The Leds; Led Indication - GE VE700AM Manuel D'installation

7. Identifying detector status by the LEDs

A) LED indication
Table 3: LED indication
= Continuously On
Detector
status
Power On
High/Low voltage
CLM
Someone enters
the curtains
PIR intruder alarm
PIR intruder alarm
Latched PIR
alarm: 1st to alarm
Latched PIR
alarm: 2nd to alarm
AM alarm
After AM reset
Technical fault
= Normal blinking (1 Hz)
= Fast blinking (4 Hz)
Yellow Red
LED LED
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- 15 -
To reset
Automatically after 70 sec.
Apply correct voltage.
Automatically after 3 sec.
Automatically after 3 sec.
Switch to Day mode.
Switch to Day mode.
See table 2, DIP switch 2
(page 12).
Switch to Night mode.
Do a successful walk test.