Starting The Device; Connecting The Parent Unit; Connecting The Baby Unit - NUK Eco Control Video Display 550VD Mode D'emploi

Note: Always connect the cables before
inserting the mains adapter into the socket.
Always follow steps 1 to 5 in "4.1
Connecting the parent unit" in that order.
4.1 Connecting the parent
unit
The parent unit can be powered by the LiPo
battery included in the delivery or via the
mains adapter. The battery can be charged
with the aid of the mains adapter included in
the delivery.
Caution! To avoid a possible malfunction,
always insert the battery into the parent unit
before connecting the mains adapter.
1. Remove the battery cover 31 on the back
of the parent unit 17, by sliding it
downwards.
2. Insert the battery included in the delivery
package into the battery compartment.
The battery will fit only one way.
3. Slide the battery cover 31 back onto the
parent unit 17.
4. Insert the small plug of the mains adapter
into the mains adapter socket 29 of the
parent unit.
5. Insert the plug into a power socket that
matches the rating given in the technical
data (see "9. Technical
page 74).
The parent unit will automatically switch
itself on and begin charging the battery.
The battery will be charged and LED 21
will start flashing.
Attention! Allow the battery to charge for
10 hours without interruption before
using the device for the first time, to
activate the full battery capacity. LED 21
flashes green during this time.
Subsequently, charging the battery will take
no more than about 6 hours, and you can
also charge the battery during operation.
Note: Battery power is permanently
shown in the status bar:

4. Starting the device

data" on
50
– Low battery power is shown
in the status bar.
– If battery power is very low,
the symbol starts flashing red. In
addition, LED 21 lights up red and a
warning appears
accompanied by a beep, to inform you
that the parent unit will switch off within
a very short time.
– LED 21 flashes green when the parent
unit is connected to mains power.
– If the parent unit is run in
mains power
battery being inserted, the
status line will show the symbol of a
power plug instead of the battery
symbol.

4.2 Connecting the baby unit

The baby unit automatically switches itself
on when it receives a fresh power signal
over the mains. This prevents the baby unit
from staying switched off when power is
restored after a short power failure.
Note: Don't install the baby unit 1 until the
battery of the parent unit 17 is fully charged.
1. Put the baby unit 1 somewhere in the
nursery where your baby will not be able
to reach it.
An optimal distance between baby and
the baby unit is from 1 to 2 m.
Make sure the camera is set up to keep
your baby in the picture at all times, even
if the zoom function is active (see
"6.16 Zoom in
page 72).
Note: Since the temperature sensor is
inside the baby unit it is important that
you do not cover it or place it near any
heat source. Direct sunlight may also
affect the reading.
2. Insert the mains adapter plug into the
socket 16 of the baby unit 1.
3. Insert the plug into a power socket that
matches the rating given in the technical
on the screen
without the
/ scroll image" on