Setting The Volume; Mute Function - NUK Eco Control Video Display 550VD Mode D'emploi

2. Use the 24 or
select the Vibrating alarm menu.
The selected symbol will be shown in red.
3. Press the button 26 to view the sub-
menu.
ON: Vibrating alarm will be activated.
OFF: Vibrating alarm will be deactivated.
The active setting will be shown in green.
4. Use the 25 or
star in front of "OFF".
At this point, you can still exit the sub-
menu by pressing the
submenu will close and you will be
returned to the previous submenu. How-
ever, to continue with your settings, con-
tinue with the next step.
5. Press the button 26 to confirm your
setting.
The setting will be stored, the menu will
be closed, and the parent unit will return
directly to monitoring mode.
The corresponding symbol in the status
bar disappears.
Note: After 15 seconds without any input
from you, the menu will be closed with the
settings unchanged and the parent unit will
return directly to monitoring mode.

6.13 Setting the volume

• Use the VOL + 33 and VOL - 34 buttons
on your parent unit to set the volume at
which you wish to hear the sound
transmissions from the monitored room.
You will hear a beep at the appropriate
volume each time you press one of these
buttons. The louder your chosen setting,
the louder the unit will beep.
The display also shows a num-
ber of bars indicating the cur-
rent volume setting. The louder your
chosen setting, the louder the unit will beep
and the more bars will appear.
Note: The transmitted sounds depend on
the VOX level setting (see "6.8 Setting the
VOX sensitivity level" on page 62). If a
27 button to
28 button to move the
button 27. The
low sensitivity level is set, low noises will
not be heard, not even if the volume is
increased. In other words, you will not be
able to hear more sounds from the moni-
tored room simply by raising the parent
unit's sound volume. If you wish to hear
more sounds from the monitored room,
you must increase the sound sensitivity
of the baby unit's microphone, by adjust-
ing the VOX level setting.

6.14 Mute function

The sound volume of the parent unit can be
set to "mute". Sounds from the monitored
room will then no longer be audible.
Attention! If the parent unit is switched to
audio monitoring only, i.e., video monitoring
has been deactivated (see "6.9 Switching
between audio and video monitoring" on
page 63), you will not be able to switch the
parent unit to mute. This prevents you from
losing all contact with your baby while using
the baby monitor.
1. To activate the mute function, press the
VOL - button 34 continuously until you
hear two beeps in short sequence.
The parent unit is now mute, meaning
that it will no longer emit any sounds at
all.
The corresponding
appears in the centre of the
screen and the status bar, and the vibrat-
ing alarm is activated.
Note: If the parent unit is switched to mute,
the vibrating alarm is automatically activated
and cannot be deactivated. This gives par-
ents a better chance of noticing an alarm or
warning on the device.
vibrating alarm can only be deactivated by
raising the volume setting.
2. To deactivate the mute function, press
the VOL + button 33.
This raises the sound volume of the par-
ent unit, and cancels the mute function
and the automatic vibrating alarm. The
corresponding symbols in the status bar
disappear.
71
symbol
In this case, the