Operating The Device - NUK Easy Control 200 Notice D'emploi

Babyphon Easy Control 200_ 02-2014 A6 Seite 24 Montag, 24. November 2014 10:46 10
1. Position the baby unit 13 somewhere in the
nursery where your baby will not be able to
reach it.
Warning! For your child's safety:
make sure that the mains cable is out
of your baby's
strangulation).
Radio waves:
– To keep your child's exposure to
radiation as low as possible, you should
ensure that a minimum distance of at
least 1 m is maintained between your
child and the baby unit.
2. Insert a mains connector jack into the
connector socket 12 of the baby unit 13.
3. Plug the mains adapter into a power socket
that conforms to the technical data (see
"4. Technical data" on page 22).
The baby unit 13 is now ready for use.
The mains adapter
illuminated.

6. Operating the device

4. Turn on the parent unit 7 by pressing the
on/off button 8 for 3 seconds:
– The parent unit 7 will now seek out a
radio connection with the baby unit 13.
Whilst it is doing this, the range indicator
reach (risk of
3 will flash.
– As soon as the radio connection is
established, the range indicator 3 will
give off a constant light.
5. As soon as your baby makes any noise, the
sound indicator 1 will flash more rapidly
and you will be able to hear the noises
through the speaker 11.
6. You can increase and decrease the volume
using buttons 9 and 10 .
Note:
– a double beep will sound at the end of
the adjustment range.
– the volume cannot be decreased to
'zero'.
indicator 14 is
24