Adding And Selecting A Camera, And Activating Patrol Mode - NUK Eco Control Video Display 550VD Mode D'emploi

If a setting has already been made, the
active setting will be shown in green. In
addition, all the activated functions are
shown in the status bar at the top of the
screen.
4. Use the 25 or
star in front of the required setting.
5H, 4H, 3H, 2H, 1H: The timer is
activated and the alarm will be signalled
after the set time.
OFF: the reminder function is off.
5. Press the button 26 to confirm your
setting.
The setting will be stored, the menu will
be closed, and the parent unit will return
directly to monitoring mode.
If activated, the corresponding symbol
will be shown in the status bar (see
"3.3 Overview of status bar indicators"
on page 47).
Note: After 15 seconds without any input
from you, the menu will be closed with the
settings unchanged and the parent unit will
return directly to monitoring mode.
When the set number of hours has
elapsed, an audible alarm is issued
and the corresponding
symbol appears in the middle of the screen.
6. To switch the alarm off, press any button.
7. To disable the reminder function before
the alarm:
– follow steps 1 to 5 described above,
select the OFF setting, and then press
the button 26
6.7 Adding and selecting a
camera, and activating
patrol mode
This NUK baby monitor can have up to four
baby units (cameras) connected at the same
time. This allows you to monitor more than
one room, or monitor the same room from
different perspectives. You can either switch
from one camera to the next yourself, or
28 button to move the
warning
activate the patrol mode. Patrol mode
automatically switches from one camera to
the next every 10 seconds. First, you will
need to add the cameras to the parent unit.
Additional baby units can be obtained from
www.nuk.de, for example.
Adding a camera
To add a camera/baby unit, proceed as
follows:
1. First make certain the parent unit is near
enough to the new baby unit you wish to
add (within range).
Move to a location that you can be
confident is within range of the baby unit
so that the parent unit can receive the
connection link signal and there are no
communication problems.
2. Make sure the parent unit and the new
baby unit are switched on.
3. Press the
The menu bar with the main menu will
appear at the bottom of the screen.
4. Use the
select the Camera menu.
The selected symbol will be shown in red.
5. Press the
submenu.
6. Use the 25 or
star in front of the required setting.
x : delete camera
+ : add camera
7. To add a camera, use the
28 button to select the Add
camera submenu.
8. Press the
submenu.
An overview appears showing four
camera symbols. The available camera
numbers for your new camera are shown
in black.
Camera numbers already in use are
shown in green.
58
button 26.
24 or 27 button to
button 26 to view the
28 button to move the
25 or
button 26 to view the next