NUK Eco Control Video Display 550VD Mode D'emploi page 63

The menu on the parent unit will be
closed and video transmission from the
selected camera/baby unit will be shown.
The number of the active camera/baby
unit is displayed in the status bar.
If the connection to the selected
camera fails, you will hear a beep
and an appropriate
symbol will appear.
The parent unit will then switch back to
the video transmission
previously active camera/baby unit.
Note: After 15 seconds without any input
from you, the menu will be closed with the
settings unchanged and the parent unit will
return directly to monitoring mode.
Patrol mode
This function is particularly useful if you are
monitoring more than one child or more than
one room, or if you wish to monitor the
same room from automatically changing
perspectives. At least two baby units/
cameras must be connected to the parent
unit in order to be able to use this function.
Patrol mode automatically switches from
one camera to the next every 10 seconds.
Camera-specific settings remain active and
can also be changed while patrol mode is
on.
To select patrol mode, proceed as follows:
1. Press the button 26.
The menu bar with the main menu will
appear at the bottom of the screen.
2. Use the 24 or
select the Camera menu.
The selected symbol will be shown in red.
3. Press the
submenu.
4. Use the 25 or
move the star in front of the "Add
camera" setting.
5. Press the button 26 to view the next
submenu.
warning
from
27 button to
button 26 to view the
28 button to
An overview appears showing camera
symbols. Camera numbers under which a
camera/baby unit is registered are shown
in green.
The patrol mode symbol will only
appear if at least two cameras/baby
units are connected.
6. Use the
move the star in front of the patrol
mode symbol.
the
At this point, you can still exit the
submenu by pressing the
The submenu will close and you will be
returned
However, to continue with your settings,
continue with the next step.
7. Press the
selection.
The menu on the parent unit will be
closed and video transmission from the
connected cameras/baby units will be
shown in sequence. The number of the
active camera/baby unit is displayed in
the status bar. in addition, the patrol
mode symbol will be shown.
In patrol mode, the VOX level is
automatically set to 5, i.e., continuous
transmission. This means that Eco-Mode
is not available in patrol mode (see
"6.8 Setting the VOX sensitivity level" on
page 62).
Note: After 15 seconds without any input
from you, the menu will be closed with the
settings unchanged and the parent unit will
return directly to monitoring mode.
Deactivating patrol mode
To deactivate patrol mode, follow steps 1 to
5 described above.
6. When you come to step 6, instead of
selecting PM, select a particular camera/
baby unit you wish to use for continuous
monitoring.
7. Press the
selection.
61
25 or 28 button to
to the previous submenu.
button 26 to confirm your
button 26 to confirm your
button 27.