PLYMOVENT MULTIDUST BANK Manuel Opérateur page 8

Storage conditions
Transport and erection
Malfunctions and emergencies
affecting the filter unit
Dismantling and disposal
0000100513/011212/0 MDB
Data sheet and general instructions
Fire
Escape of noxious substances
or radiation
Temperature in storage 5-45°C
Atmospheric humidity in storage 75%
- Instruct all persons whose presence is not required to stay
out of the hazard area
- Do not stand under or next to the load when it is being lifted
up or set down
- Transport the unit or erection components on the pallets
provided, and secure them against falling over or slipping.
- Transport them with a suitable pallet truck or forklift truck
- The filter unit with a maximum height of 2550 mm (100")
(MDB 6)can be lifted via the support frame connection (item
10) with a forklift truck. Care must be exercised, since the
centre of gravity lies in the upper half of the unit
- Taller units should be built up on site
- Filter units must be secured to the foundations
- The foundations must have adequate load-bearing strength
and be free of vibration
- In the event of fire, an approved extinguisher for fire classes
A, B and C should be used
- The manufacturer must be contacted
- The MultiDust Bank contains no noxious substances.
- If the filter ruptures, welding fumes can be released into the
building; welding activities must be suspended and the
MultiDust Bank repaired
- Only a qualified electrician may disconnect the machine or
the electrical system
- Before dismantling it the machine must be disconnected from
the power supply and from the external compressed air
supply
- Before dismantling it, clean the equipment
- The dismantling area must be cleaned afterwards
- During dismantling work, the working area must be
adequately ventilated; this can be achieved by provision of a
mobile ventilation unit
- During dismantling work, wear appropriate personal
protective equipment. We recommend half-face breathing
masks to DIN EN 141/143, protection class P3
- The pollutants and dust, together with the dirty filter
cartridges, must be properly disposed of in a professional
manner in accordance with statutory instructions, using the
plastic sack disposal system supplied
7
0