PLYMOVENT MULTIDUST BANK Manuel Opérateur page 12

waRNiNg!
Never use the product for:
- oxy-fuel cutting
- aluminium laser cutting
- oil mist
- paint mist
- extraction of hot gases (more than 80°C/176°F
continuously)
- grinding aluminium and magnesium
- flame spraying
- extraction of cement, saw dust, wood dust, grit
etc.
- explosive environments or explosive substances/
gases
- Note: this list is not all-embracing
installation
- The installation of this product is exclusively reserved to
authorised, well-trained and qualified engineers.
- Inspect the product and check it for damage. Verify the
functioning of the safety features.
- Electric connection to be executed in accordance with local
requirements. Ensure compliance with the EMC regulatory
arrangements.
- Check the working environment. Do not allow unauthorized
persons to enter the working environment.
- Protect the product against water and humidity.
- Use common sense. Stay alert and keep your attention to
your work. Do not use the product when you are under the
influence of drugs, alcohol or medicine.
- Ensure the workspace is well-illuminated.
- Make sure the room is always sufficiently ventilated; this
applies especially to confined spaces.
- Never install the product in front of entrances and exits
which must be used for emergency services.
- Make sure that the workshop, in the vicinity of the product,
contains sufficient approved fire extinguishers.
- Make sure the wall, ceiling or support system are strong
enough to carry the product.
- Air containing particles such as chromium, nickel,
beryllium, cadmium, lead etc., which is a health hazard,
should never be recycled. This air must always be brought
outside the working area.
0000100513/011212/0 MDB
use
- During use, always use Personal Protective Equipment
(PPE) to avoid injury. This also applies for persons who
enter the work area.
- Check the working environment. Do not allow unauthorised
persons to enter the working environment.
- Protect the product against water and humidity.
- Make sure the room is always sufficiently ventilated; this
applies especially to confined spaces.
Service, maintenance and repairs
attENtiON!
Maintenance should only be performed by
authorized, qualified and trained persons (skilled)
using appropriate work practices.
waRNiNg!
After switching off, wait at least 20 seconds before
opening the door to carry out service,
maintenance or repair jobs.
- Observe the maintenance intervals given in this manual.
Overdue maintenance can lead to high costs for repair and
revisions and can render the guarantee null and void.
- During service, maintenance and repair jobs, always use
Personal Protective Equipment (PPE) to avoid injury. This
also applies to persons who enter the work area during
installation.
- Always use tools, materials, lubricants and service
techniques which have been approved by the manufacturer.
Never use worn tools and do not leave any tools in or on
the product.
- Safety features which have been removed for service,
maintenance or repairs, must be put back immediately
after finishing these jobs and it must be checked that they
still function properly.
- Use sufficient climbing gear and safety guards when
working on a higher level than 2 meter.
- Ensure the workspace is well illuminated.
11
0