Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en
26
Instructions for core drilling.
Do not stop the drill motor during the drilling
procedure.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
counterclockwise.
After each drilling operation, remove the
chips and the slug.
Error message/
Response of magnet
button
Indicator lights up
green
Indicator flashes
green
Indicator flashes red
once or several times
Indicator lights up red
continuously
Indicator does not
light up
Meaning
Magnetic holding power possi-
bly sufficient.
Magnetic holding power insuf-
ficient.
– Motion sensor has actuated
– Overload shut-off has actu-
ated
– Hand lever not set to 100 %
position
– Buttons for left rotation/right
rotation blocked
– Check battery indication
Power tool is defective.
– The machine is in sleep func-
tion
– Battery dead or defective
– Power tool is defective
Do not touch the chips with your bare
hands. Always use a chip hook (6 42 01
001 00 0).
Danger of burning!
When changing a cutting tool, pay attention
not to damage the cutting edges.
For core drilling in layered material, use a suit-
able Slugger ID cutter.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
Corrective action
Even when working on steel materi-
als where the material thickness is
below 9 mm, the workpiece must be
made thicker with an additional steel
plate in order to ensure the magnetic
holding power.
After malfunction correction, the
power tool can be switched on again.
Send the machine to your Slugger
customer service agent.
– Actuate magnet button (sleep func-
tion is deactivated).
– Check battery indication
– Send the machine to your Slugger
customer service agent.
Publicité
Table des Matières
