Fein Slugger AJMU137 PMQW Mode D'emploi page 24

en
24
Starting and stopping the drill motor
Fig. 15
(figure 15).
To start the drill motor with clockwise rota-
tion, press the button with the „ " symbol.
The drill motor starts with the highest speed.
To lower the speed, press the „ " symbol.
100 %
l
To increase the speed, press the „ " sym-
85 %
l
75 %
l
60 %
bol.
l
50 %
l
25 %
l
100 %
l
85 %
l
75 %
l
60 %
l
50 %
l
25 %
l
The last set speed is automatically stored
Memory Function
(memory function). To start the power tool
with the last set speed, press and hold the
button with the symbol, and then press
the button with the symbol .
To stop the drill motor, press the „ "
button.
To start the drill motor with counterclock-
wise rotation, press the button with the
„ " symbol. The drill motor will run as
long as the button is pressed.
When the power supply is disconnected
while the drill motor is running (e.g. removal
of the battery), a protective circuit prevents
automatic restarting of the drill motor. Restart
the drill motor again.
Do not stop the drill motor during the drilling
procedure.
In case of overload, the drill motor automati-
cally stops and must be restarted again.