Fein Slugger AJMU137 PMQW Mode D'emploi page 28

en
28
Repair and customer service.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools, hand pump, battery
Drill-motor guide (figure 18).
After several hours of operation, the play in the dove-tail guide can increase. As a consequence,
the drill motor can glide along the dove-tail guide by itself. This can lead to the motor drifting
down and damaging the cutting tool. In this case, retighten all fastening screws of the dove-tail
guide correspondingly so that the drilling motor can easily be moved manually, yet does not
glide by itself.
Fig. 18
2,5 mm/
3/32 in
Fastening
screws
2,5 mm/
3/32 in
Drill-motor
guide
2,5 mm/
3/32 in