Fein Slugger AJMU137 PMQW Mode D'emploi page 17

Changing the tool (figure 7).
Before mounting or replacing
WARNING
application tools or accesso-
ries, remove the battery. This preventive
safety measure rules out the danger of injuries
through accidental starting of the power tool.
Always secure the power tool
WARNING
with with the provided safety
strap. When carrying out such work, beware
of falling objects, such as core bits or chips.
Core drill bit
Insert the pilot pin into the cutter.
Pull the clamping sleeve of the tool holder
down and insert the core drill bit with the
centering pin into the tool holder.
Do not touch the sharp edges of the core drill
bit. Danger of injury.
Drill chuck
Pull the clamping sleeve of the tool holder
down and insert the drill chuck.
Drill bit
The knurled nut has a left-hand thread; turn
clockwise to release!
Loosen the knurled nut and remove the tool
holder by applying a hammer blow to the
positioned drift.
Clean the inside cone of the output shaft and
insert the drill bit.
Fig. 7
3.
4.
2.
3.
2.
1.
4.
Knurled
nut
en
2.
Centering pin
1.
Core drill bit
1.
Drill chuck
5.
3.
MK 2
MT 2
CM 2
Drill bit
17