Grundig Digta 7 PUSH Mode D'emploi page 20

introduction
introduction
This operating manual contains important instructions for safe and
En
efficient handling of the Grundig Business Systems Digta 7 (her-
einafter referred to as "device"). This operating manual is a part of the
device and must be kept accessible in the immediate vicinity of the
device for persons working on and with the device. Carefully read and
make sure you understand this operating manual and all product safety
labels prior to starting any work with the device. The basic prerequisite
for safe work is compliance with all specified safety and handling
instructions. In addition, all local accident prevention guidelines and
general safety regulations effective at the implementation site of the
device apply. Illustrations in this operating manual are provided for basic
understanding and can vary from the actual model of the device. No
claims can be derived from the illustrations in this operating manual
Disclaimer
All information and instructions in this operating manual have been pro-
vided under due consideration of applicable guidelines and regulations,
the current and known state of the art, as well as our many years of in-
house experience. The manufacturer assumes no liability for damages
due to:
•
Failure to comply with the instructions in this operating manual
•
Improper use / misuse
•
Willful operation by non-authorized persons
•
Unauthorized conversions or non-approved technical modifications
16
•
Use of non-approved spare parts
The originator is solely liable to the full extent for damages caused by
such conduct. The agreed upon obligations in the delivery contract, the
general terms and conditions, the manufacturer's delivery conditions,
and the statutory regulations valid at the time the contract was conclu-
ded, apply.
copyright
This operating manual is protected by copyright. No part of this operating
manual may be reproduced in any form or incorporated into any infor-
mation retrieval system without written permission Grundig Business
Systems GmbH ("the manufacturer"). Delivery of the operating manu-
al to third parties, duplication in any form – including excerpts – as well
.
as exploitation and/or communication of the content, are not permitted
without a written declaration of release from manufacturer. Actions to the
contrary make damage compensations mandatory. We reserve the right
to enforce additional claims.
The manufacturer
© Grundig Business Systems GmbH
Weiherstraße 10
D – 95448 Bayreuth
holds the copyright.