SOUNDMASTER NMC549DABBE Guide Rapide page 19

E) track separation(On remote control only)
You can divide the recording music from tape or Aux/DAB etc. in to USB track by track during encoding. Every time when press
the " " (track separation) button (on remote control) once during encoding from tape or Aux in, the system will generate a
new track and continuous the recording. The text "SAVE" at LCD display will flash one time, it means the unit is creating a new
track successfully.
F) Copying of MP3 file
If putting a MP3 disc instead of a CD-disc, the system will copy the files to the USB if press the "
operation procedures is same as CD encoding as stipulate on above, and the system will switch to copying mode only if MP3
file being read.
File delete at USB (by remote control)
The system is able to erase the file stored inside the USB pen drive by following:-
1． Insert the media storage and set at "USB" mode.
2． Press the "delete" button and the LCD display (6) will show (del ---001)
3． Press skip forward
4． Press the "delete" button to enter "yes/no" mode and then press skip forward
"no".
5． Press the "delete" button again to confirm the setting.
Remark:
Press "stop" button once at remote handset to quite delete mode
-
Phono
Operation
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before
-
operating and re-secured again afterwards.
IMPORTANT
before use:
The device has a transport protection!
Rotate this with your hand or a piece of money (Clockwise to the right) completely!
Please keep the dust cover open when playback the record.
DO NOT Close the dust cover during playback.
Select to "Phono" function from function selector (5)
1.
Set the speed selector (27) to the proper position depending on the record to be played.
2.
Place the record on the platter (use the spindle adaptor if required).
3.
Set the Tone arm lever (26) to the up position.
4.
Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate and position the tone arm
5.
over the desired position of the record.
Pull down the Tone arm lever (26). The tone arm will come slowly on the recorder and start playback.
6.
At the end of record, the tone arm will return to the rest position automatically.
7.
To stop manually, lift the tone arm from the record and return it to the rest.
8.
⚫ Play suspension
Set the cueing lever (26) to the up position will life up the tone arm and then stop playback temporarily
Remark:
Due to the auto return system was mechanical design and reset point will be affected after transportation.
-
Thus, the tone arm will return to the rest automatically when first time place it to the platter and it was
not the malfunction
Due to the length of the record is various, if you find the tone arm cannot return automatically after
-
playback of record. Please return the tone arm back to the rest position manually or adjust the auto
return point as below procedure.
or skip backward button to select the file going to delete
NMC549DABBE / English Instruction Manual
REC" button (10). The
or skip backward
Stylus assembly
to select "yes" or
Cartridge
7