Hayward AQUAVAC Mode D'emploi page 6

Masquer les pouces Voir aussi pour AQUAVAC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Plus
1.
For installation and normal use of Plus, please refer to the chapter on general use.
2.
In order for the remote control to operate properly, the power supply box must be placed in an unobstructed
location about twenty metres from the remote control. The remote control can be used at any time during the
cycle without the cycle being interrupted.
3.
In order to control a Plus cleaner, press and hold the buttons of the remote control that correspond to the action
you wish to perform. Once you have released the button, a Plus cleaner automatically resumes its normal cycle.
If a Plus cleaner does not operate when you press the button:
Check that you are pointing the remote control towards the power supply box and not towards th cleaner.
Check that there is no obstacle between the power supply box and the remote control
The distance between the power supply box and the remote control should be no longer than 20 metres. The
closer you are to the power supply box, the better the reception.
Check the battery of the remote control: if necessary, replace it with a new battery (1x CR2032 Lithium).
The voltage surge protection might have tripped. Reactivate it by depressing the button located above the
connection of the cleaner power supply cable on the power supply box.
Check that the rotation actuator is not clogged with debris. For this purpose, remove the cleaner from the water,
and operate the actuator by hand to clear the debris: the actuator should be able to move easily.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
6

Publicité

Table des Matières
loading

Table des Matières