Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Check The Height Of The Waterline On The Cleaner:
•
Ensure that the filter is clean.
•
Put the cleaner in the water and observe the height of the waterline on the cleaner. For this purpose,
let it perform several cleaning cycles in order to determine an average height.
•
Once the waterline is settled, if the cleaner regularly makes excessive rattling noises, takes air in through the
bottom cover, climbs up the edge of the wall instead of going back the other way, or if it tends to stagnate in the
same zone of the pool, it is probable that the cleaner is climbing too high: install the reducer kit.
Optimum Waterline Height
For The Cleaner To Operate Properly
The best water temperature for optimum operation of the cleaner lies in the range 10°C to 35°C. However, the cleaner
can be used in water at a different temperature.
Regular cleaning of the filter cartridge after use, every time the cleaner is used, optimizes performance of the
appliance. If the cleaner is struggling to climb up the walls of the pool, wash the filter and then resume pool cleaning.
Replace the brushes (12) when they are worn to maintain effective cleaning.
If granulated chemical products are used on a daily basis in the pool, we recommend using a floating or automatic
metering feeder because such a feeder retains the calcium sediment that is sometimes contained in that type of
product. It is recommended not to use the cleaner before all of the chemical powders are not dissolved because they
could clog the filter.
In a hard-water pool, more frequent cleaning of the filter is advised. Keep the cleaner packaging for storing it or
transporting it (in case any repairs are necessary).
The motor unit (13) and the power supply box (1) do not contain any parts that are of use to the user. If they are
opened the warranty automatically becomes NULL AND VOID.
Quick Clean (QC)
1.
For installation and normal use of QC, please refer to the chapter on general use.
2.
In order to select the normal cycle or the economy cycle, please follow the following instructions: on switching
on, the economy programme is automatically selected. The "Quick Clean" light, situated on the control box, then
comes on. In this mode, The cleaner will switch off automatically after 90 minutes.
3.
In order to select the normal programme, please press the "Full Cycle" button. The light situated above the
button comes on and indicates that the normal programme is running. In this mode, The cleaner will switch off
automatically after 4 hours.
If the economy mode is finished, you should switch off the cleaner and then switch it back on in order to select
normal mode: normal mode can be selected only during an economy cycle.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Incorrect Waterline Height
5
Publicité
Table des Matières
