Megger BMM2500 Guide De L'utilisateur page 20

given by a printer, and therefore waits at the end of
each line. This time ("Printer delay time") and the
printer report language can be changed.
1. Press and hold the
rotary selector switch from the OFF position to
the RCL position. The code Pdt is displayed.
2. Release the
To change the Printer speed
1. Toggle the
display the code Pdt
2. Press the
displayed.
∼
3. Toggle the
required setting is displayed.
4. To save the new setting, press the
The bleeper sounds and std is displayed. To
abort the new setting, press the EXIT button.
To select the printer language
1 . P ress the
play the code l n g.
2 . P ress the
language is displayed as 1 (English) or 2 (as
given on the type label on the User Guide cover).
key then turn the
key.
key to scroll through and
key. The current setting is
and keys until the
key to scroll through and dis-
key. The current printer re p o r t
Note: Language 2 can be changed – see below.
3. Press the
setting is displayed
4. To save the new setting, press the
The bleeper sounds and is Std displayed. To
abort the new setting, press the EXIT button.
Changing the Second Printer Language
Language 2 can be changed using AVO Download
Manager Program supplied with your instrument. Full
instructions are contained in the User Guide with the CD.
Data-logging
Enabling/disabling data-logging:
The factory setting is that logging is disabled and
key. storage is enabled.
1. Turn the range knob to 'RCL' while holding
down the
2. Press the
3. Press the
of the logging function, i.e on or off.
4. Pressing the
between on and off.
5. Press the
EXIT button to quit.
key until the required language
key. Pdt will be displayed.
key until log is showing
key to show the current status
key toggles the setting
key to accept the setup, or the
key.
19