Storing Results - Megger BMM2500 Guide De L'utilisateur

∼
key.
1. Set the selector switch to mA.
2. Connect the test leads.
3. Select either a.c. or d.c. m A using the
∼
k e y.
4. Press and hold down the TEST button for
approx. 2 seconds.
5. After a short settle time, the reading will be
displayed automatically.
To view the frequency of the a.c. mA being mea-
sured press the
displayed in the range 16Hz-460Hz. To view a.c.
mA press the key again. For inputs less than
10mA frequency is not displayed.
key. The frequency will be
Storing Results on MΩ and Ω (RCL)
After an insulation test or continuity test the result
is displayed on the screen, this may be saved with
additional information. A circuit number (1-99) may
be assigned and circuits may be grouped using the
distribution board feature. In this way, when down-
loading to AVO PowerSuite, the results can be eas-
ily split into different test schedules. When the
results are displayed or printed, a change in the
distribution board is indicated.
Changing Distribution Boards (DB)
Before a test the distribution board number may be
changed as follows:-
1. Move the rotary selector switch to the RCL
position. The code rcl is displayed.
2. Press the key. The currently selected DB
code is displayed, e.g. d01.
3 . This number may be changed using the
and keys to display the re q u i red number.
4. The number can be accepted by pressing the
key, or aborted by pressing the EXIT button.
5. When the number is saved the code Std is
displayed (accompanied by a long bleep) to
confirm that the data has been saved.
∼
13