29 8.8 Fastening The Tape Measure Holder; 29 8.9 Aligning The Sct 415 S52 Using; The Setting Aid; Setting Calibration Board Height - Bosch SCT 415 S52 Notice Originale

en 44 | SCT 415 S52 | Operation
8.8 Fastening the tape measure holder
Abb. 13: Fastening the tape measure holder
1 Securing screw
2 Knurled screw
1. Lessen the fixing screw.
2. Attach tape measure holder to the cross beam.
3. Tighten the securing screw.
4. Place tape measure in tape measure holder and
secure it with the knurled screw.
1
Abb. 14: Tape measure / mount
1 Reading line
|
1 690 386 051 2020-10-22
8.9
1
i
1. Place the setting aid on the star knob screw.
2. Use the spirit levels on the precision holder to align
2
Abb. 15: Aligning the SCT 415 S52 by setting aid
1 Setting aid
8.10
1. Find the required height of the calibration board in
2. Check if there is a difference in height between the
3. If there is a difference in height between the resting
4. Attach the calibration board.
5. Operate the locking handle, and use the ruler to set
Aligning the SCT 415 S52 using

the setting aid

The setting aid is available as an optional accessory.
the SCT 415 S52 by means of the setting aid.
1

Setting calibration board height

the manufacturer's "Repair instructions".
resting surface of the vehicle and the resting surface
of the SCT 415 S52 (for example, because a lift is
used).
surfaces, compensate by adjusting the height given
in the short instructions accordingly.
the calibration board to the required height.
Robert Bosch GmbH