Intended Users; Agreement; Obligation Of The Shop Owner/Operator - Bosch SCT 415 S52 Notice Originale

en 30 | SCT 415 S52 | Symbols used
¶
Always fit and check the safety systems immediately
after maintenance and repair work.
¶
Immediately after completing maintenance and repair
work, fit and check the safety systems.
¶
The cross beam, reflector unit and laser projectors are
calibrated and adjusted. The removal or adjustment of
any screws fixed to them is not allowed. Calibration can
only take place at the manufacturer's plant.
¶
Do not place any load on the reflector unit, reference
boards, camera calibration board or cross beam.
2.2

Intended users

The product may only be used by trained and instructed
personnel. Apprentices or personnel undergoing training,
induction or instruction may only use the product under the
continual supervision of an experienced person.
2.3

Agreement

By using the product, you agree to the following terms:
Copyright
The software and data are the property of Bosch GmbH
or its suppliers and protected against copying under copy-
right law, international agreements and other national regu-
lations. Copying or selling of data and software or any part
thereof is illegal and liable to prosecution. In the event of any
infringements, Bosch GmbH reserves the right to pur-
sue criminal prosecution and damages.
All data in this program is based on manufacturer and im-
porter information wherever possible. Bosch GmbH
accepts no liability for the accuracy and completeness of
the software and data. No liability is accepted for damage
arising from faulty software or data. In any event, any liability
on the part of Bosch GmbH is limited to the amount ac-
tually paid by the customer for this product. This exemption
from liability does not apply to damage intentionally caused
or arising from gross negligence on the part of Bosch
GmbH.
|
1 690 386 051 2020-10-22
Warranty
The use of unapproved hardware or software is considered
a modification of our products and leads to the exclusion of
any liability or warranty, even if such hardware or software
has been removed or deleted again in the interim.
No modifications may be be made to our products. Our
products may only be used with genuine accessories and
genuine spare parts. Otherwise, all warranty claims will be
rendered null and void.
2.4

Obligation of the shop owner/operator

The shop owner/operator has an obligation to provide and
perform all appropriate means and measures to prevent
accidents, occupational diseases and occupational health
risks as well as to perform all appropriate measures to make
the workplace fit for people to work in.
Basic rules
The workshop owner/operator must ensure that electrical
equipment and operating material are only set up, modi-
fied and maintained by a qualified electrician or under the
guidance and supervision of a qualified electrician in ac-
cordance with electrical-engineering principles.
If a piece of electrical equipment or operating material is
found to be defective, i.e. it does not or no longer comply
with electrical-engineering principles, the shop owner/
operator must ensure that the fault is rectified immediately
and, wherever there is an imminent danger present, that the
electrical equipment or the electrical operating material is
not used in its defective state.
Robert Bosch GmbH