Factory Defaults - Arrma Granite 550 Mega Guide Rapide

If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Motor Connectors
Battery Plug
Throttle Setup
Do not move the throttle when switching the model on as the ESC will
automatically set the throttle neutral. A long beep will sound to confirm
setup.
Input Voltage
ESC Status LED
Low Voltage Cut Off
Battery Mode

Factory Defaults

Setting 'Jumpers'
6-7 NiMh (7.2-8.4v) / 2S Lipo (7.4v)
LED blinking slowly: Partial Forward/Reverse/Brake
LED solidly on: Full Forward/Reverse/Brake
Heat-sink
NiMh
4.5v
Battery Mode: NiMh
Reverse: On
19
HEAT-SINK MAY BE HOT AFTER USE
Power Switch Receiver Plug
BEC Output
LiPo
6.4v
WWW.ARRMA-RC.COM
(CH2)
6.0v/2A Max