Factory Defaults - Arrma 4x4 3S BLX Vehicle Mode D'emploi

Factory Defaults

Binding
Bind socket
Insert the Bind Plug in the
BIND port on the receiver.
TH
N R N
ST TRIM ST TRIM ST TRIM
TH TRIM
Center the ST TRIM and TH
TH RATE ST RATE
TRIM dials on the transmitter.
TH LIM
50/75/100
OFF
Remove the Bind Plug, then
power off the receiver to save
the settings.
Connect a fully charged battery
pack to the ESC.
ST
R
Turn the steering wheel to full
right. Power the transmitter
on while holding the steering
wheel to the right.
Power off the transmitter.
ON
Power on the ESC. The red
LED flashes, indicating the
receiver is in bind mode.
Release the steering wheel
when the receiver LED stops
18
flashing.
WWW.ARRMA-RC.COM