Log Placement - Napoleon Ascent 30 Serie Manuel D'installation Et D'opération

10.6

log placement

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
logs exclusive to Napoleon, provide a unique and realistic glowing effect that is different in every
PHAZER
TM
installation. Log colours may vary. During the initial use of the appliance, the colours will become more uniform as
colour pigments burn in during the heat activated curing process.
A. Place the rear log (W135-0575) firmly onto the
two studs at the rear of the support tray.Ensure
the log sits flat and does not cover the pilot
opening. Place two pins in the holes located
on the top rear of the rear log.
B
C. Position the right log (W135-0577) onto the
two studs located on the right side of the log
support. Place one pin into the hole located
on the top of the right log.
PINS
A
PIN
A
C
B
B. Place the left log (W135-0576) onto the two studs
located on the left side of the log support.
D
B
D. Place the left crossover log (W135-0578) onto
the pin located in the left side of the rear log,
allow it to rest in the notch of the left log.
finishing
48.1
A
A
C
W415-1768 / B / 08.10.18
EN
49