Safety Barrier / Door Removal And - Napoleon Ascent 30 Serie Manuel D'installation Et D'opération

10.0 finishing
finishing
EN
WARNING
!
• Risk of fire!
• Never obstruct the front opening of the appliance.
• The front of the appliance must be finished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specified dimension, as illustrated.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
• Facing and/or finishing material must never overhang into the appliance opening.
• The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishing
or other materials must not be located in the opening surrounding the door as this will interfere with the doors
ability to relieve pressure.
10.1 safety barrier / door removal and installation
WARNING
!
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from the hot viewing glass is provided for the appliance
and shall be installed.
Before the glass door can be removed, the safety barrier must be removed. Lift the safety barrier off the 4 pins,
tilt the top forward and remove from the appliance.
Leave a hand on the glass door during entire door removal. The glass door is secured
to the firebox with 2 spring latches along the top and 2 along the bottom. Pull the
handles of the latches forward, then lift the latches out from the door frame to release
the top of the door. Repeat the same step for the 2 bottom latches. Next, pivot the
door forward until the top edge clears the front of the appliance. Carefully grip the
sides of the door lifting it off the appliance.
note:
These spring latches make up the spring relief system for the appliance. Ensure
they open freely and close sealed.
Reverse these steps to re-install the safety barrier and door. Ensure safety barrier is installed correctly.
44
W415-1768 / B / 08.10.18
47.1