Identification; Product Description And Type Designation; Product Markings; Preparing The Product For Use - Videotec HOV Hi-PoE Manuel D'instructions

4 Identification

4.1 Product description and type
designation
The HOV Hi-PoE/HOV PoE is an innovative and
stylish housing, designed to simplify installation and
servicing for the IP and Megapixel cameras, thanks
to the benefits of Hi-PoE/PoE (Power over Ethernet).
This technology allows to feed the 12Vdc cameraszas
well as the heater directly from the Ethernet cable.
No need to add external power sources or bring
additional power cables into the enclosure.
If your network does not have Hi-PoE/PoE, you
can add it by using the 1 channel Power Injector
(accessory available as an option), in addition
Videotec certifies the compatibility of the Microsemi/
PowerDsine HiPoE Multi Port 7000 Midspans series
(available in 6,12 and 24 port versions).
The HOV Hi-PoE/HOV PoE housing ensures total
protection against all environmental conditions. Due
to its side opening, the accessibility to the camera,
lens and all its connections is made far easier. Its
weatherproof features are ensured by neoprene-
rubber gaskets and 3 cable glands with their specific
gaskets, or by the sealing gaskets, when installed
with bracket with internal cable management.
The body is made of die-cast aluminium; the
sunshield of ABS material. The sunshield with its
integrated edge-protector offers good thermical
insulation. HOV Hi-PoE/HOV PoE offers the possibility
of various mountings: wall or ceiling brackets,
standard or full cable management brackets, or Pan
& Tilt heads.
A specific version with a very efficient cooling system
is available for high environmental temperature.

4.2 Product markings

See the label attached to the outside of the package.
4
5 Preparing the product
for use
Any change that is not expressly approved
h
by the manufacturer will invalidate the
guarantee.

5.1 Contents and unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• RJ45 wiring
• Housing equipment:
• Allen wrench
• Spacers
• Cable glands (x3)
• Cable glands gaskets
• Screws and washers
• Screws for camera
• Desiccant salt bag
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.