Repair And Ordering Of Spare Parts; Disposal And Recycling; Ec-Declaration Of Conformity - Batavia RACER BT-CS006 Mode D'emploi

• Clean the electric power tool regularly with a
damp cloth and somewhat soft soap. Do not
use any cleaning or solvent materials; these
can attack the device's plastic components.
Make sure that no water can get inside the
electric power tool.
Carbon brushes
In the event of excessive sparking, allow a
qualified person to examine the carbon brushes.
Attention! The carbon brushes may only be
exchanged by a qualified person.
maintenance
There are no further parts requiring maintenance
inside the electric power tool.

9. rEPAIr And ordErIng oF SPArE PArTS

Exchanging the power cable
If the power cable of this electric power tool is
damaged, it must be replaced by the
manufacturer, its customer services department
or a similarly qualified person to avoid danger.
Spare parts/Accessories
Spare parts and accessories can be ordered
through our web shop: www.batavia.eu

10. dISPoSAl And rECyClIng

Do not dispose of electric power tools
with domestic refuse.
The electric power tool is shipped in packaging to
reduce transport damage. This packaging is a raw
material and as such can either be reused or can
be fed back into the raw material cycle. The
electric power tool and its accessories are made
from various materials such as metals and
plastics. Take defective components to a special
refuse collection point. Ask about these at your
specialist shop or local council.
The product and the user manual may be subject
to changes. Technical data may be changed
without prior notice.

EC-declaration of conformity

We, the batavia gmbh, blankenstein 180,
nl-7943PE meppel, declare by our own
responsibility that the product Precision Circular
Saw, Item-no 7060453, model nr.
bT-CS006 is according to the basic requirements,
which are defined in the European Directives
Electromagnetic Compatibility (EmC),
2006/42/EC (machinery), 2006/95/EC low
Voltage directive (lVd) and their amendments.
For the evaluation of conformity, the following
harmonized standards were consulted:
En 60745-1: 2009+A11,
En 60745-2-5: 2010, En 55014-1: 2006+A1
En55014-2: 1997+A1+A2,
En 61000-3-2: 2006+A1+A2, En 61000-3-3: 2008
Meppel, 01 June 2011
Meino Seinen, QA Representative
Batavia GmbH, Blankenstein 180,
7943 PE Meppel, Netherlands
EN
29