System Settings - Smanos L020 Manuel D'utilisation

EN

System settings

Edit Accessory
①
10 remote controls and 30 sensors could be extended and the
names of sensors are editable.
This function aims at guiding user to identify the invasion location
quickly by changing the sensor name. Their sequence in naming
follows pairing order, for example, the first paired sensor is by
default assigned to zone 1, the second paired sensor is by default
assigned to zone 2, etc. In case of emergency, this control panel
will push notification with zone number (or new name) to user.
Meanwhile, you can change the working mode of accessory
(Except the 24-hour zone sensor) by tapping the
please refer to the detail of "zone mode" on page 8.
Wireless Siren
②
If wireless siren is purchased, you can setup on the app to turn on/
off the alarm function and arm/disarm tone, etc.
13
[ ] or [ ],
Exit Delay Time & Entry Delay Time
③
If you don't want to carry along remote controls, you can set the
exit or entry delay.
Suppose entry delay is set at 30 seconds, the system will allow you
30 seconds to disarm the system before alarming. Suppose exit
delay is set at 35 seconds, the system will allow you 35 seconds to
leave before the system is armed. The "beep" is heard in every 2
seconds to remind you to leave. The pace of reminding sound will
speed up in the last 15 seconds. Thus leaves you enough time to
leave home without triggering the system.
User Deletion
④
Input the ID No. (on the back side of the control panel) to delete
all the users.
EN
14