Connect Keypad To Control Panel; Connect Rfid Tag To Keypad - Smanos WK7000 Mode D'emploi

EN
Note: Open the rear cover of keypad will trigger tamper switch, please dismiss
the alarm by following the disarm instruction on page 21-22.
2. When connected with electric door lock as an access control,
keypad is suggested to use the specific power supply for access
control.
To know connection steps, please refer to the instruction manual of
electric door lock. The electric door lock and specific power supply
for access control should be purchased respectively.

Connect Keypad to Control Panel

Make sure the control panel is in connecting state (please refer to
the user manual of control panel), input user code or admin code
on keypad, and then press any key of.
The connection succeeds after one beep.
User can remotely control the panel via the keypad after connection.
Note: If the control panel beeps twice when connecting, it means the keypad
has been already connected with the panel.
5
[Arm] [Disarm] [Stay Mode].
The default user code is 1234.
①
The default admin code is 123456.
②
Connect Keypad with RFID Tag
1. Input [admin code] + [#] to wake up keypad.
Three beeps mean wrong input.
Wrong input for 6 times continuously, the keypad will be locked for
20 seconds.
EN
6