Faq - Smanos WK7000 Mode D'emploi

EN

FAQ

Problem
Low battery
The positive and
negative terminals
No response are reversed
from keypad
Keypad is locked by
inputting wrong
passcode continually
more than 6 times
No response from
Keypad
alarm panel
cannot
connect to
control panel
Alarm panel beeps
twice
Keypad is not
learned to control
No response
panel
from the
control panel
Distance between
by operating
keypad and control
on keypad
panel is too far
27
Cause Solution
Please change the battery
Follow the right terminal
direction and insert the battery
again
Keypad will be unlocked after
non-operation for 20 seconds
Make sure the alarm panel is
powered on
Make sure the alarm panel
enters learning state
Keypad has been learned
Please connect the keypad to
the control panel by following
the manual instruction
Please move the keypad in a
proper distance where control
panel can receive the signal of
keypad
It's recommended to buy signal
repeater to extend the distance
The RFID tags are
not learned to
keypad
Cannot
disarm by Disarm by RFID tag
RFID Tags function is
deactivated
Direct disarm by
RFID tag is disabled
Keypad is not waked
up
Keypad
cannot be
Keypad doesn't enter
programmed
setup state
Keypad
cannot be Haven't input user
armed, code or admin code
disarmed and before operation
in stay mode
EN
Please connect the RFID tag to
control panel by following the
manual instruction
Enter setup state and activate
the function of disarm by RFID
tag
Disarm after pressing [*] key
Please input [admin code] + [#]
to wake up the keypad
Please input [admin code] +
[#], and press [3] to enter setup
state
Please input the user code or
admin code before operation
28