ST Quadrat LUX-top FALZ-PLUS Manuel D'utilisation page 21

Installation spacings:
The distances from the edge are to be chosen in accordance with the national provisions
and depending on the roof geometry.
The correct choice and layout of anchor devices provided permanently on the roof must be
made depending on the type and use of the anchor device and taking into account the
special features of the roof.
Information on the recommended type and positioning of anchor points is provided, for
example, in BGI 5164 / DGUVI 201-056 "Planungsgrundlagen von Anschlageinrichtungen
auf Dächern" (Planning principles for anchor devices on roofs), which were drawn up and
agreed by the international expert work group D-A-CH-S.
The brochure is available, for example, at
downloaded free of charge.
National provisions are not affected by these recommendations. Where these suggestions
differ from national law, the user of these recommendations bears the full legal risk to the
scope of the deviation.
Allowable distances between anchor points in the
As pure, individual anchor points
With temporary horizontal anchor devices
®
LUX-top FSE
With
systems
If you are at all uncertain, please contact the manufacturer
*Results from the edge fall problem of connectors for horizontal use.
Directly at the fall edge, work to the side of the anchor point should be limited to max. 1.5 m distance from the anchor point!
Combination with other LUX-top products:
®
LUX-top FALZ-PLUS
The
•
corner point and as an intermediate point (optionally also with traversable rope guide
(anchor line)) in the
EN 795 Type C + CEN/TS16415:2013. In this case, also note and follow the user
instructions of the
®
LUX-top FALZ-PLUS
The
•
devices / temporary horizontal flexible anchor lines to EN 795 Type C. To this end,
note and follow the instructions for use of the respective temporary system!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.lux-top-absturzsicherungen.de
2003
stainless steel rope
product can be used as an extremity (start or end) or
®
LUX-top
®
LUX-top FSE 2003
product can be used with temporary horizontal anchor
page 5
www.lux-top-absturzsicherungen.de
®
LUX-top FALZ-PLUS
Maximum 3.0 m*
7.5 m maximum
Larger distances are possible depending on the system
Maximum 7.5 m (recommended)
Maximum 15 m (in accordance with test certificate)
FSE 2003
stainless steel
system!
version 01/2016
and can be
system
rope system to