Connecting The Pullcord Switch - Vent-Axia Lo-Carbon IQ Mode D'emploi

NB!
Use an ordinary round file to
create a smooth cut-out at a
suitable place in the front cover.
Do NOT use pliers or similar
tools, as these may cause the
cover to crack.
5. Connecting the pull cord switch
A pull cord can be installed for activating the timer manually or for
pausing the fan. Remove the mounting plate using a screwdriver, for
example, and thread the accompanying pull cord through the hole.
•
Once installation is complete, push the safety switch down
to position I – ON, to make the fan active again.
When the fan is connected to the power supply, it performs a
self-test where electronics, LEDs and operation of the motor are
all tested. The fan is now ready for use.
8