Publicité
8A-1-8 HOW TO USE THIS MANUAL
HOW TO READ CONNECTOR LAYOUT DIAGRAM
When necessary to know the location of an electrical part or an intermediate connector, it is easily possible to
retrieve it by this diagram.
First consult "SYSTEM CIRCUIT DIAGRAM" section or connector table at the right hand pages of this section for
the questioned connector code. Second refer to the diagrams of this section and look for the same code.
More information on use of the code is illustrated below.
Connector code
L 0 1
Connector No (serial No : 01)
Harness symbol (Refer to the table below)
Harness symbol and corresponding harness name
A : Battery harness
B : A/C harness
C : Engine harness
D : Injector harness
E : Main harness
G : Instrument panel harness
J : Door harness
L06
L08
L07
(K03)
L22
L17
L14
L25
(K01)
L30
L03
L02
(O01)
(O02)
L01
L10
L11
L12
L19
L18
L21
L20
(J15)
L13
L31
L32
(R01)
L26
(G08)
L27
(G07)
K : Roof wire
L : Floor harness
N : Rear defogger wire
O : Back door harness•Hi mount stop lamp wire
Q : Air bag harness
R : Fuel pump harness
This indicates the ground point No.
The same No. is used as the ground point. (For the
details, refer to "GROUND POINT" section)
This indicates the connector code.
The connector code in the parentheses ( ) has the
same meaning as the above intermediate connec-
tor and at the same time, it indicates that there is a
harness continuity between pages or illustrations in
}
"CONNECTOR LAYOUT DIAGRAM" section. That
is, it suggests that the harness is continued to the
other page or illustration and the continued harness
can be identified by the same connector code.
Publicité
Chapitres
