Operation - Meister MAS12V Traduction Du Manuel D'utilisation Original

• Red:
The rechargeable battery must be
charged.
9 – Operation
Torque pre­selection
The cordless drill/screwdriver has
a torque setting function with 20+1
levels which helps to avoid damage
to the screw or drill head. By rotating
the torque setting (2) on your cordless
drill/screwdriver, you can select the
required level, from 1 (easy screw­
driver action) through to maximum
(heavy­duty screwdriver/ drilling
action). Always select the most appro­
priate torque for the job in hand.
Do not use the drill setting for
screwdriver work.
Tensioning a tool
Traditional screwdriver bits, bit
holder and drills up to a diameter of
10 mm can be used in the chuck (1).
Only use a tool that can be clamped
securely in the chuck and which is
designed for use with this machine.
See „Technical data".
The machine has a quick­action
chuck (1). This allows you to change
accessories by hand quickly and
without a chuck key.
• Open the claws of the quick­ac­
tion chuck. To do this, rotate the
quick­action chuck anti­clockwise.
Open the quick­action chuck far
74
enough to be able to insert the tool.
MW-5450770-Bedien-1905.indd 74
• Insert the tool in the quick­action
chuck.
• Rotate the quick­action chuck
clockwise and tighten securely.
CAUTION! Accidentally
switching the machine on is
an injury risk. Set the switch for
the rotation direction to the mid­
dle setting when the machine is at
a standstill in order to activate the
lock for the On/Off switch.
CAUTION! Risk of cuts.
• Wear gloves to insert a drill into
the quick­action chuck.
• Tighten the quick­action chuck
to clamp the tool in place.
The chuck of right/left rotat­
ing machines is always fixed
with a left­threaded screw. This
must be loosened from the front
through the chuck (1) before
changing it. Left­threaded screws
can only be loosened by turning
to the right.
Switching on and off (Figure 5)
• Switching on:
Press the On/Off switch (10). The
screwing/drilling process starts.
During the screwing/ drilling pro­
cess, keep the switch pressed.
The LED working light (11) will
light up.
08.05.19 14:32