Meister MAS12V Traduction Du Manuel D'utilisation Original page 73

• Low weight
• Long lifetime
Removing the rechargeable bat­
tery (Figure 2)
Press the battery unlock button (8)
and pull the battery pack (7) out
battery holder (9).
Inserting the battery pack
(Figure 2)
Slide the rechargeable battery (7) as
far as it will go into the battery hold­
er (9) and allow it to click into place.
Charging the battery pack
(Figure 3)
CAUTION! The rechargeable
battery is not completely
charged when it leaves the facto­
ry. Charge the battery pack before
using for the first time.
CAUTION! Only use the sup­
plied charger to charge the
rechargeable battery (12).
CAUTION! Check the
voltage specifications of the
charger (12) with the voltage of
your mains power supply before
plugging the charger in.
1. Plug the charger (12) into the
socket. The charging status check
light (13) on the charger (12) lights
up in green and signals when
ready to operate.
MW-5450770-Bedien-1905.indd 73
2. Slide the rechargeable battery
through the charging cradle (14)
over the contacts of the
charger (12) until it clicks audibly
into place. During the charging
process, the charging status
check light (13) on the charger
turns to red.
3. The charging process should take
about 60 minutes. It is finished as
soon as the red LED goes out and
the green LED lights up.
4. Press the unlocking button (8)
on the rechargeable battery and
remove the rechargeable battery
from the charger.
CAUTION! The rechargeable
battery is to be removed from
the charger after the charging
time is complete. A constant
warming of the charger and the
battery is normal and is not a
fault.
Battery pack charge monitoring
(Figure 4)
To monitor the charge state, the
battery capacity status display (4)
lights up during operation.
The charge state is shown as fol­
lows:
• Green/Yellow/Red:
The rechargeable battery is fully
charged.
• Yellow/Red:
The rechargeable battery is par­
tially discharged.
73
08.05.19 14:32