Mounting And Positioning - Bushnell TROPHY CAM HD AGGRESSOR Mode D'emploi

MOUNTING and POSITIONING

the Trophy Cam HD Aggressor
Mounting
After you've set up the camera's parameters to your personal preferences at home
or in your truck, you're ready to take it outside and slide the power switch to "ON".
When setting up the Trophy Cam HD Aggressor for scouting game or other
outdoor applications, you must be sure to mount it in place correctly and securely.
We recommend mounting the Trophy Cam HD Aggressor on a sturdy tree with
a diameter of about 6 in. (15cm). To get the optimal picture quality, the tree should
be about 16-17 ft. (5 meters) away from the place to be monitored, with the camera
placed at a height of 5-6.5 ft. (1.5~2 m). Also, keep in mind that you will get the
best results at night when the subject is within the ideal flash range, no farther than
80ft/24m (119876/119877) or 100ft/30m (119874/119875) and no closer than
10ft (3m) from the camera.
There are two ways to mount the Trophy Cam HD Aggressor: using the provided
adjustable web belt, or the tripod socket.
Using the adjustable web belt: Fig. 5 illustrates using the web belt on the Trophy
Cam HD Aggressor. Push one end of the belt through the two brackets on the
back of the Trophy Cam HD Aggressor. Thread the end of the strap through the
buckle. Fasten the belt securely around the tree trunk by pulling the end of the strap
firmly so there is no slack left. Using the tripod socket: The camera is equipped
with a socket at the bottom end to enable mounting on a tripod or other mounting
accessories with a standard1/4-20 thread.
Fig. 5: Attaching the Belt
26
Belt Channel
Strap Buckle