Setup Mode - Bushnell TROPHY CAM HD AGGRESSOR Mode D'emploi

to its current parameter settings) when it is triggered by the PIR sensor's detection of
activity in the area it covers.
You can either move the power switch directly from OFF to ON mode, or stop at the
SETUP position first to change one or more settings, then move the switch to ON
after you have finished doing so.

SETUP MODE

In the SETUP mode you can check and change the settings of the Trophy Cam
HD Aggressor with the help of its built-in LCD. These settings, found in the SETUP
Menu, let you change the photo or video resolution, interval between photos, switch
the time imprint on, etc. Moving the power switch to the SETUP position will turn on
the LCD display, and you will see an information screen that shows how many images
have been taken, the battery level, camera or video mode, etc (Fig. 3, next page).
NOTE: Always move the power switch from OFF to SETUP mode. It is possible
that the camera could lockup if it is switched from ON to SETUP mode. If this
occurs, simply move the switch to OFF and then push it up to SETUP again.
SETUP Mode Shortcut Keys/Functions
As mentioned earlier in "Parts & Controls", four of the keys below the LCD
have secondary, "shortcut" functions when the camera is switched to SETUP mode
(but the MENU key has not been pressed):
• Press the UP key to quickly set the camera to shoot video clips.
• Press the DOWN key to quickly set the camera to take still photos.
• Press the RIGHT key to manually trigger the shutter. This is useful for testing
the camera-make sure you are in SETUP mode, press the RIGHT key, and a
few seconds later a photo or video (depending on how the camera was set) will
be saved to the SD card (or internal memory if no card is inserted). The "number
of images taken" counter on the bottom left of the LCD will increase by one. If
the display indicates "SD LOCKED" when you press the SHOT key, switch the
camera OFF, remove the SD card and slide its lock switch off.
11