Bushnell TROPHY CAM HD AGGRESSOR Mode D'emploi page 35

2. LCD screen shows a faint black line after turning from "Setup" to "On".
The LCD will turn off when you slide the switch to the "On" position. In some
cases, this black line will appear and then fade in about 1 second. This is
normal and the camera will function properly.
3. Screen comes on but then powers off
Make sure that you have installed the SD card correctly.
Camera won't retain settings
Make sure that you have been saving the changes to any parameter settings
that you made while in Setup mode, by pressing "OK" after changing the
setting. If you don't save your new setting after changing it, the camera will
continue to use the original default setting for that parameter.
Moisture or Ants Inside Camera
1. To ensure humidity or rain is kept out of the camera, secure the DC In plug
firmly in place.
2. Ants can be attracted by low level electronic vibrations, and enter through any
gaps between the exterior and interior of the camera. Make sure the DC In plug
is securely attached.
Field Scan (Time Lapse) not working properly
1. Make sure that the stop and start times of Field Scan "A" and "B" do not overlap
(for example, do not set the start time of "B" to 8AM if the stop time of "A" is
10AM).
2. When using Field Scan in video mode, the smallest interval time available is 5
min, to avoid potential overheating of the batteries and electronic components,
which could cause operational failure or damage to the camera. In still photo
mode, a 1 min. Interval can be set.
CAUTION: DO NOT USE the 0.6s Interval setting for Video at night
at a feeder or similar environment. It may cause the LEDs to
continue firing over a long period of time, which may overheat and
shorten the operating life of the internal electronic components.
Do not mix battery types-use ALL lithium or ALL alkaline.
Do not mix old and new batteries.
Rechargeable batteries are not recommended.
35